Equator 2WD V6-4.0L (2009)
2) Remove the M/T finisher.
3) Remove the retaining plate and dust boot covers.
4) Remove the clip (B) and then separate the boot from the control housing.
5) Remove the guide plate bolts and then separate the guide plate.
6) Remove the shift lever assembly and spring from the transmission.
INSTALLATION
Installation is the reverse order of removal.
^
Install shift knob according to the following.
-
Apply cement to threads of control lever assembly.
-
Tighten shift knob until increased tension is felt. Then align shift knob to the position as shown within one turn.
CAUTION:
Do not adjust shift knob by loosening it.
CAUTION:
^
Apply multi-purpose grease to socket and bushing.
^
Insert bushing of control lever assembly as far as it will go into the hole of striking arm.
^
Tighten guide plate (1) bolts to the specified torque in order as shown.
