Equator 2WD V6-4.0L (2009)
^
Position clip as shown.
^
Be careful with the orientation of control lever boot and insulator.
INSPECTION AFTER INSTALLATION
^
Tighten guide plate bolts to the specified torque.
^
When shift lever assembly is shifted to each position, make sure there is no binding or disconnection in either boot.
^
When shifted to each position, make sure there is no noise, bending, and backlash. Especially when shift lever assembly is shifted to 5th, 6th
without pressing downward, check for bending.
^
When shift lever assembly is shifted to 1st, 2nd side and 5th, 6th side, confirm shift lever assembly returns to neutral position smoothly.
^
In any position other than reverse, confirm that shift lever assembly can be pressed downward.
^
With shift lever assembly pressed downward, confirm that it can be shifted to reverse.
^
When shifted from reverse to neutral position, confirm shift lever assembly returns to neutral position smoothly with spring power.
^
Without shift lever assembly pressed downward, confirm that it cannot be shifted to reverse.