Equator 2WD V6-4.0L (2009)
3. If the rear window glass is to be reused, mark the body and the glass with mating marks.
WARNING: When cutting the glass from the vehicle, always wear safety glasses and heavy gloves to help prevent glass splinters from
entering your eyes or cutting your hands.
CAUTION:
-
When the rear window glass is to be reused, do not use a cutting knife or power cutting tool.
-
Be careful not to scratch the glass when removing.
-
Do not set or stand the glass on its edge. Small chips may develop into cracks.
INSTALLATION
Installation is in the reverse order of removal.
-
Use an Urethane Adhesive and follow the instructions furnished with it.
-
While the urethane adhesive is curing, open a door window. This will prevent the glass from being forced out by passenger compartment air
pressure when a door is closed.
-
The molding must be installed securely so that it is in position and leaves no gap.
-
Check gap along bottom to confirm that glass does not contact sheet metal.
-
Inform the customer that the vehicle should remain stationary until the urethane adhesive has completely cured (preferably 24 hours). Curing time
varies with temperature and humidity.
WARNING:
-
Keep heat and open flames away as primers and adhesive are flammable.
-
The materials contained in the kit are harmful if swallowed, and may irritate skin and eyes. Avoid contact with the skin and eyes.
-
Use in an open, well ventilated location. Avoid breathing the vapors. They can be harmful if inhaled. If affected by vapor inhalation,
immediately move to an area with fresh air.
-
Driving the vehicle before the urethane adhesive has completely cured may affect the performance of the rear window in case of an
accident.
CAUTION:
-
Do not use an adhesive which is past its usable term. Shelf life of this product is limited to six months after the date of manufacture.
Carefully adhere to the expiration or manufacture date printed on the box.
-
Keep primers and adhesive in a cool, dry place. Ideally, they should be stored in a refrigerator.
-
Do not leave primers or adhesive cartridge unattended with their caps open or off.
-
The vehicle should not be driven for at least 24 hours or until the urethane adhesive has completely cured. Curing time varies
