Equator 4WD V6-4.0L (2010)
Evaporator Temperature Sensor / Switch: Service and Repair
Intake Sensor: Removal and Installation
Removal
1. Remove the front kick plate. Refer to [Body Side Trim: Removal and Installation].
2. Remove the lower dash side finisher. Refer to [Instrument Panel Assembly: Exploded View].
3. Remove the front pillar lower finisher. Refer to [Body Side Trim: Removal and Installation].
4. Remove the assist grip handle. Refer to [Body Side Trim: Component].
5. Remove the front pillar upper finisher. Refer to [Body Side Trim: Removal and Installation].
6. Remove the lower glove box. Refer to [Instrument Panel Assembly: Exploded View].
7. Remove the upper glove box (cluster lid E). Refer to [Instrument Panel Assembly: Exploded View].
8. Disconnect the intake sensor electrical connector.
NOTE: The intake sensor is located on the top of the heater and cooling unit assembly next to the A/C evaporator cover.
9. Twist the intake sensor to remove the intake sensor from the heater and cooling unit assembly.
Installation
Installation is in the reverse order of removal.