Esteem L4-1590cc 1.6L SOHC 0 MFI 16V (1995)
4. Set rocker arm shaft so that its cut part faces down and becomes in parallel with head cover mating surface.
5. Install rocker arm shaft bolts and tighten them to specified torque.
Tightening Torque (a): 11 Nm (96 inch lbs.)
6. Fill small amount of engine oil into arm pivot holding part of rocker arm shaft. Install rocker arm (intake side) with clips to rocker arm shaft.
7. Apply engine oil to cams and journals on camshaft and put camshaft on cylinder head. Install camshaft housing to camshaft and cylinder head.
-
Apply engine oil to sliding surface of each housing against camshaft journal.
-
Apply sealant to mating surface of No.6 housing which will mate with cylinder head.
"A" Sealant: 99000-31110
