Esteem L4-1590cc 1.6L SOHC 0 MFI 16V (1995)
7. If valve lash is out of specification, adjust it to specification by turning adjusting screw after loosening lock nut. After adjustment, tighten lock nut
to specified torque while holding adjusting screw stationary, and then make sure again that valve lash is within specification.
Valve clearance specification (intake and exhaust):
When cold (Coolant temperature is 15 - 25°C or 59 - 77°F): 0.13 - 0.17 mm (0.005 - 0.007 inch)
When hot (Coolant temperature is 60 - 68°C or 140 - 154°F): 0.17 - 0.21 mm (0.007 - 0.008 inch)
Special Tool, or equivalent (A): 09917-18210
Tightening Torque (a): 12 Nm (108 inch lbs.)
8. After checking and adjusting valve lashes at valves (1), (2), (5) and (7), (or (3), (4), (6) and (8)) rotate crankshaft exactly one full turn (360°) and
check the same at valves (3), (4), (6) and (8) (or (1), (2), (5) and (7)). Adjust them as necessary.
9. After checking and adjusting all valves, reverse removal Procedure for installation.