Esteem L4-1590cc 1.6L SOHC 0 MFI 16V (1995)
3. Remove snap ring of reverse clutch drum with bearing,
4. Install sun gear input flange (thrust washer installed) with retainer ring.
5. Mount reverse clutch drum with bearing to oil pump body.
6. Measure pack clearance with compressed air (57 - 113 psi) through oil hole section (A), using Special Tools (A): 09900-20606 and (B):
09900-20701, or equivalent.
Specified value: 0.64 - 1.50 mm (0.025 - 0.059 inch)
NOTE:
^
To prevent air leakage from oil hole section (A) during pack clearance measurement with air nozzle gun, it is recommended to plug oil
hole section around air nozzle gun with a clean cloth or the like because pack clearance cannot be measured otherwise.
^
If it is difficult to obtain correct specified value above, it is recommended to align plate (Thickness: approximately 3 mm) with shape
around oil hole section.
DISASSEMBLY
1. Remove reverse clutch drum with bearing from oil pump body.
2. Remove sun gear input flange with thrust washer installed by removing retainer ring.
3. Remove No.3 clutch discs and clutch plates in following order. (1) Plate -> (2) Disc -> (3) Plate -> (4) Disc
