Esteem GL Wagon L4-1.8L (1999)
5. Remove pipe cover from body.
6. Put clamp position mark on pipes so that clamps can be installed on original position.
7. Remove pipes with clamp from body.
8. Remove clamp from pipes.
INSTALLATION
1. Install clamps to marked position on pipes. If clamp is deformed or its claw is bent or broken, replace it with new one.
2. Install pipes with pipe clamp to body.
3. Install pipe cover to body. Be sure to use new nuts.
4. Connect fuel hoses and pipes to each pipe.
CAUTION: When connecting joint, clean outside surfaces of pipe inserted to joint, push joint into pipe till joint lock clicks and check to ensure
that pipes are connected securely, or fuel leak may occur.
5. Connect brake pipe joints.
6. With engine "OFF" and ignition switch "ON", check for fuel leaks.
7. Bleed air in brake system.
