Esteem GLX Sedan Plus L4-1.6L (1998)
8. Before removing oil pan, remove CKP sensor from oil pan. Remove oil pan and then oil pump strainer.
CLEANING
-
Clean mating surface of oil pan and cylinder block.
Remove oil, old sealant, and dusts from mating surfaces and oil pan inside.
-
Clean oil pump strainer screen.
-
Clean CKP sensor.
INSTALLATION
1. Apply sealant to oil pan mating surface continuously as shown in figure.
"A" Sealant: 99000-31150
2. Install oil pump strainer and oil pan.
Install O-ring into cylinder block securely as shown in figure.
With oil pump strainer inserted into oil pan, install strainer to cylinder block.
Tighten strainer bolt first and then bracket bolt to specified torque.
Tightening Torque (a): 11 Nm (8.0 ft. lbs.)
After fitting oil pan to cylinder block, run in securing bolts and start tightening at the center: move wrench outward, tightening one bolt at a time.
