Esteem GLX Sedan Plus L4-1.8L (1999)
Valve Cover: Service and Repair
REMOVAL
1. Disconnect negative cable at battery.
2. Remove ignition coil cover.
3. Disconnect ignition coil couplers.
4. Remove ignition coils.
5. Remove oil level gauge.
6. Disconnect breather hose and PCV hose from cylinder head cover.
7. Remove cylinder head cover.
INSTALLATION
1. Remove oil, old sealant, and dust from sealing surfaces on cylinder head and cover. After cleaning, apply sealant "A" to cylinder head sealing
surface area as shown in figure.
"A": Sealant 99000-31150
2. Install 0-rings and cylinder head cover gasket to cylinder head cover.
NOTE: Be sure to check each of these parts for deterioration or any damage before installation and replace if found defective.
3. Install cylinder head side seal and cylinder head cover to cylinder head