suzuki Workshop Repair Guides

Suzuki Workshop Service and Repair Manuals

Power Steering Pump|Removal and Installation|Page 2921 > < Power Steering Pump|Removal and Installation|Page 2919
Page 5
background image

^

Check free length of relief valve spring.
Free length:

Standard 22.0 mm (0.866 inch) 
Limit 19.0 mm (0.748 inch) 

Replace if any defective is found.

ASSEMBLY 

Reverse disassembly procedure for assembly, noting the following.

1. Apply grease to oil seal lip and apply power steering fluid to sliding surface of the shaft then insert pulley's shaft from oil seal side of the pump

body.
"A": Grease 99000-25010 

2. Apply power steering fluid to O-rings and fit them to pump body.

3. Install side plate to pump body.

NOTE:  Carefully align the dowel pins on the side plate at bolt hole as shown in figure.

4. Apply power steering fluid to sliding surface of rotor.

Power Steering Pump|Removal and Installation|Page 2921 > < Power Steering Pump|Removal and Installation|Page 2919