Esteem GLX Wagon L4-1.8L (1999)
CAUTION:
^
Wash each part cleanly before installation in the same fluid as the one used in master cylinder reservoir.
^
Never use other fluid or thinner.
^
Before installing piston and piston seal to cylinder, apply fluid to them.
^
After reassembling brake lines, bleed air from them.
Piston Seal
Piston seal is used to seal piston and cylinder and to adjust clearance between pad and disc. Replace with a new one at every overhaul. Fit piston seal
into groove in cylinder taking care not to twist it.
Piston and Boot
1. Before inserting piston into cylinder, install boot onto piston as shown.
2. Fit boot, as it is in the image, into boot groove in cylinder with fingers.
Check to make sure that boot is fitted into boot groove in cylinder completely in its circumference.
3. Insert piston into cylinder by hand and fit boot in boot groove in piston.
4. To confirm that boot is fitted in its groove in cylinder properly, pull piston out of cylinder a little but do not take it all out.
NOTE: Boot's face "B" should be at the same level from cylinder's face "A" all around.
