Esteem GLX Wagon L4-1.8L (1999)
3. If measurement is out of specified value, adjust depth by turning adjusting screw of piston rod.
Special Tool (C): 09952-16020
BOOSTER PUSH ROD CLEVIS ADJUSTMENT
Install push rod clevis so that measurement "a" is obtained and torque nut to specification.
Tightening Torque (a): 25 Nm (2.5 kg.m, 18.0 ft. lbs.)
Length "a": 114.5 - 115.5 mm (4.51 - 4.55 inch)
INSTALLATION
NOTE:
^
All brake fasteners are important attaching parts in that they could affect the performance of vital parts and systems, and/or could result in major
repair expense. They must be replaced with one of same part number or with an equivalent part if replacement becomes necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to assure proper retention of all
parts. There is to be no welding as it may result in extensive damage and weakening of the metal.
^
Check length of push rod clevis.
^
Before installing master cylinder, adjust booster piston rod.
^
Apply silicone grease to master cylinder piston.
1. Install booster to dash panel as shown. Then connect booster push rod clevis to pedal arm with clevis pin and clip.
