Esteem GLX Wagon L4-1.8L (1999)
^
Check oil seal lip for fault or other damage.
Replace as necessary.
NOTE: When installing new oil seal, drive it in until its surface is flash with edge of timing chain cover. To install oil seal, use special tool
(bearing Installer).
Special Tool
(A): 09913-75510
INSTALLATION
CAUTION: When raising engine, be careful not to raise it excessively and not to cause transmission to contact body, steering gear box, etc.
Excessive raise may cause damage to engine, transmission, etc.
Reverse removal sequence to install timing chain cover noting the following points.
1. Apply sealant "A" and "B" to area as shown in figure.
"A": Sealant 99000-31150
"B": Sealant 99000-31140
2. Apply engine oil to oil seal lip, then install timing chain cover. Tighten bolts and nut to specified torque.
