Esteem GLX Wagon L4-1.8L (1999)
10. Disconnect three connectors for contact coil and combination switch wire harness from junction/fuse block.
11. Remove contact coil and combination switch assembly from steering column.
INSPECTION
Check contact coil and combination switch wire harness for any signs of scorching, melting or other damage. If it is damaged, replace.
INSTALLATION
1. Check to make sure that vehicle's front tires are set at straight ahead position and then ignition switch is at "LOCK" position.
2. Install contact coil and combination switch assembly to steering column.
NOTE: New contact coil and combination switch assembly is supplied with contact coil set and held at its center position with a lock pin and
seal. Remove this lock pin after installing contact coil and combination switch assembly to steering column.
3. Connect three connectors for contact coil and combination switch wire harness to junction/fuse block.
