Esteem GLX Wagon Plus L4-1.6L (1998)
Cruise Control Servo: Service and Repair
CRUISE CONTROL ACTUATOR ASSEMBLY (WITH CONTROL MODULE)
CAUTION: Never disassemble cruise control actuator assembly. Disassembly will spoil its original function.
Removal
1) Disconnect negative cable from battery.
2) Disconnect connector from actuator assembly (with control module).
3) Remove actuator cap from actuator assembly.
4) Disconnect cruise cable from actuator assembly.
5) Remove actuator assembly from vehicle.
Inspection
Move actuator lever by hand and check its operation as described below.
1) Actuator lever should not turn clockwise.
2) Actuator lever should turn smoothly by about 1/3 rotation counterclockwise and contact internal stopper.
3) When hand is taken off from actuator lever at the position in 2) above, it should return to its original position by return spring force. If actuator
lever does not operate as described above, replace it.
Installation
Install actuator assembly by reversing removal procedure, noting following point.
-
Adjust cruise cable play to specification referring to "cruise cable".
