Esteem GLX Wagon Plus L4-1.6L (1998)
9. Install rocker arm shaft plug and timing belt inside cover. Then tighten rocker arm shaft plug to specified torque.
Tightening Torque (a): 33 Nm (24.0 ft. lbs.)
10. Install camshaft timing belt pulley to camshaft while fitting pin on camshaft into slot at "E" mark.
11. Using special tool, tighten pulley bolt to specified torque.
Tightening Torque (a): 60 Nm (43.5 ft. lbs.)
Special Tool (A): 09917-68220
12. Install belt tensioner, timing belt, outside cover, crankshaft pulley, water pump belt and engine right mounting bracket and stiffener.
13. After applying sealant to part "A" as shown in figure at the left, install CMP sensor case to cylinder head and tighten its fixing bolts to specified
torque.
"A" Sealant: 99000-31110
Tightening Torque (a): 11 Nm (8.0 ft. lbs.)
Install ignition coil assembly.
