Esteem GLX Wagon Plus L4-1.6L (1998)
5. Remove exhaust No.1 pipe mounting nuts (3 pieces).
6. Remove exhaust manifold and its gasket from cylinder head.
7. Remove exhaust No. 1 pipe gasket from exhaust No. 1 pipe.
INSPECTION
-
Check gasket and seal for deterioration or damage. Replace them as necessary.
INSTALLATION
1. Install new gaskets to cylinder head and exhaust No. 1 pipe.
2. Install exhaust manifold.
Tighten manifold bolts and nuts and exhaust No.1 pipe mounting nuts to specified torque.
(a): 23 Nm (17.0 ft. lbs.)
(b): 50 Nm (36.5 ft. lbs.)
3. Install exhaust manifold cover.
4. Connect heated oxygen sensor coupler and clamp its wire securely.
5. Install exhaust No.1 pipe to exhaust pipe rear stiffener, and install exhaust pipe front stiffener.
6. Connect negative cable at battery.
