Esteem GLX Wagon Plus L4-1.6L (1998)
Shift Rail: Service and Repair
GEAR SHIFT & SELECT SHAFT ASSEMBLY
1. To disassemble component parts, use Special Tools (A): 09922-85811 (4.5 mm) and (B): 09925-78210 (6.0 mm) and 2.8 - 3.0 mm (0.11 inch) pin
remover in addition.
2. Clean all parts thoroughly, inspect them and replace with new ones as required.
3. Assemble component parts by reversing removal procedure.
NOTE:
^
When driving in spring pins, prevent shaft from being bent by supporting it with wood block.
^
Assemble 5th & REV gear shift cam by winding cam guide return spring, and then drive in spring pin.
^
Locate low speed select spring (Blue-Lower position) and reverse select spring (Red-Upper position) correctly.
