Esteem GLX Wagon Plus L4-1.8L (1999)
2. After greasing (lithic grease) bearing outer race, bearings and oil seal lips, install them.
Inside Oil Seal
With hole in inside oil seal matched with projection on knuckle (for vehicle without ABS) or wheel speed sensor installation hole in knuckle (for
vehicle with ABS), drive in Oil seal until its stepped surface contacts knuckle by using special tools (C) and (E).
NOTE: When driving in oil seal, be careful not to deform or tilt it or not to cause damage to rubber part.
Special Tools:
(C): 09924-74510
(E): 09944-66010 or equivalents.
Outside Oil Seal
Drive in oil seal until its end contacts with snap ring using special tools (C) and (E). As for its installing direction, refer to figure.
Special Tools:
(C): 09924-74510
(E): 09944-66010 or equivalents.
