Esteem GLX Wagon Plus L4-1.8L (1999)
6. Remove knuckle.
INSTALLATION
1. Install knuckle to ball stud on suspension arm and strut bracket. Installing direction of each bolt is as shown. Align knuckle bolt hole with ball stud
groove as shown and install ball stud bolt. Tighten each nut to specified torque. (Refer to the exploded view.)
2. Install ABS wheel speed sensor to knuckle, if equipped. Tighten sensor bolt to specified torque referring to the exploded view.
NOTE: Check to make sure that ABS wheel speed sensor tooth is free from any metal particles.
3. Connect tie-rod end to knuckle and tighten tie-rod end castle nut to specified torque. Install new split pin.
4. For installation procedures following the above, refer to Wheel Hub, Service and Repair.
OIL SEALS, SNAP RING AND WHEEL BEARING
REMOVAL
Once bearing outer race is removed, bearing set (outer race, bearings and inner races) should be replaced with new one.
