Forenza L4-2.0L (2004)
4. Install the generator-to-intake manifold strap bracket and bolts.
Tighten: Tighten the generator-to-intake manifold strap bracket bolts to 22 Nm (16 ft. lbs.).
5. Install the intake manifold support bracket.
6. Install the intake manifold support bracket upper bolts to the intake manifold.
Tighten: Tighten the intake manifold support bracket upper bolts to the intake manifold to 25 Nm (18 ft. lbs.).
7. Install the intake manifold support bracket lower bolt to the engine block.
Tighten: Tighten the intake manifold support bracket lower bolt to the engine block to 25 Nm (18 ft. lbs.).
8. Install the generator-to-intake manifold support bracket and bolts.
Tighten: Tighten the generator-to-intake manifold support bracket bolts to 37 Nm (27 ft. lbs.).
9. Install the fuel rail and injector cover as an assembly.
10. Install the throttle cable bracket.
11. Install the throttle cable bracket bolts.
Tighten: Tighten the throttle cable bracket bolts to 8 Nm (71 inch lbs.).
12. Connect the throttle cable to the intake manifold and the throttle body.
13. Connect all of the necessary vacuum lines that were previously disconnected.
14. Connect the MAP sensor connector.
15. Connect the coolant hoses to the throttle body.
16. Connect the IAC valve connector.
