Forenza L4-2.0L (2004)
Cylinder Head Gasket: Removal and Replacement
Cylinder Head and Gasket Removal and Installation
Tools Required:
KM-470-B Angular Torque Gauge
J-28467-B Engine Assembly Support Fixture
Removal
1. Remove the fuel pump fuse.
2. Start the engine. After it stalls, crank the engine for 10 seconds to rid the fuel system of fuel pressure.
3. Disconnect the negative battery cable.
4. Disconnect the Electronic Control Module (ECM) ground terminal.
5. Drain the engine coolant.
6. Disconnect the Manifold Air Temperature (MAT) sensor connector.
7. Disconnect the breather tube from the camshaft cover.
8. Disconnect the air cleaner outlet hose from the throttle body.
9. Disconnect the Direct Ignition System (DIS) coil connector.
10. Disconnect the oxygen (O2) sensor connector, if equipped.
11. Disconnect the Idle Air Control (IAC) valve connector.
12. Disconnect the Throttle Position Sensor (TPS) connector.
13. Disconnect the Engine Coolant Temperature (ECT) sensor connector.
