Forenza L4-2.0L (2004)
Brake Bleeding: Service and Repair
Manual Bleeding the Brakes
Manual Bleeding the Brakes
1. Remove the booster reserve by applying the brakes several times with the engine OFF until all the reserve is depleted.
2. Fill the master cylinder reservoir with brake fluid. Keep the master cylinder at least one-half full of fluid during the bleeding operation.
3. Disconnect the front brake line(s) at the master cylinder.
4. Allow the brake fluid to fill the master cylinder until it begins to flow from the front pipe connector port.
5. Connect the front brake line(s) to the master cylinder.
Tighten: Tighten the brake lines to 16 Nm (12 ft. lbs.).
