Forenza L4-2.0L (2004)
12. Remove the idle air control (IAC) valve. Refer to Idle Air Control Valve Removal and Installation.
Installation
CAUTION: Use care in cleaning old gasket material from machined aluminum surfaces. Sharp tools may damage sealing surfaces.
1. Clean the gasket mating surface on the intake manifold.
2. Clean the throttle body.
3. Install the TP sensor. Refer to Throttle Position Sensor Removal and Installation.
4. Install the IAC valve. Refer to Idle Air Control Valve Removal and Installation.
5. Install the throttle body assembly with a new gasket to the intake manifold.
6. Install the throttle body retaining nuts.
Tighten: Tighten the throttle body retaining nuts to 10 Nm (89 in. lbs.).
7. Connect the TP sensor connector and the IAC valve connector.
8. Connect the coolant hoses to the throttle body.
9. Connect the vacuum hoses to the throttle body.
10. Connect the throttle cable.
11. Install the air intake tube.
12. Connect the breather hose to the valve cover.
13. Connect the IAT sensor connector.
14. Connect the negative battery cable.
