Forenza L4-2.0L (2004)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Lock Cylinder and Switch Removal and Installation
Removal
1. Disconnect the negative battery cable.
2. Remove the upper and the lower steering column cover panel by removing the screws.
3. With the key in the ignition turned to the position designated ACC, remove the lock cylinder by pressing down the detent spring and pulling the
lock cylinder out of the switch cylinder housing .
4. Remove the ignition switch retaining screw.
5. Disconnect the wiring and remove the ignition switch.
Installation
1. Install the ignition switch with the ignition switch retaining screw.
^
Tighten the ignition switch retaining screw to 2.5 Nm (22 inch lbs.).