Forenza L4-2.0L (2004)
2.
Connect the Tech 2 to the DLC and navigate to the "TEC Learn of CKP sensor". Follow the TEC path shown at the bottom of the screen to the
right.
3.
Allow the engine time to warm up to at least 149 degrees fahrenheit.
4.
Press enter. Press enter again when prompted at the screen that says "Press ENTER To START".
5.
The TEC screen will now look like the screen to the right before the TEC Learn is started.
6.
In order to start the TEC Learn process push the "YES" button on the key pad. Note the YES = ON at the bottom left of the screen.
7.
Once "YES" is pushed the TEC learn status will say "In Progress" at the right in the status location.
8.
With the "TEC learn status" showing "In Progress", press the accelerator pedal down until the engine RPM increases to fuel cut off. (4,000+ RPM)
9.
Continue to hold the pedal for 5 to 10 seconds. The engine RPM will rise and drop 2 to 3 times.
10.
Release the pedal when the engine starts to surge past 4,000 RPM.
