Forenza L4-2.0L (2004)
Tie Rod Boot: Service and Repair
Dust Boot Removal and Installation
Tools Required: KM-3-22610 Installer
Removal
1. Raise and suitably support the vehicle.
2. Remove the wheel.
3. Remove the outer tie rod.
4. Remove the dust boot retaining clamps.
5. Remove the dust boot.
Installation
1. Install the dust boot.
2. Install the tie rod end dust boot retaining clamp. Install the cylinder end dust boot retaining clamp with the installer KM-3-22610.
3. Install the outer tie rod.
4. Install the wheel.
5. Lower the vehicle.
