Forenza L4-2.0L (2004)
12.
Remove the disk set C & D using your fingers and pulling the disk set straight out.
13.
Remove wave washer from the back side of the disk set C & D assembly, apply assembly lubricant (Assemblee Goo ) as shown and set aside for
reassembly.
14.
Discard the old disk set C & D.
15.
Submerge the new disk set C & D assembly in a pan with clean transmission fluid, coating all of the plates with transmission fluid.
16.
Note the location of the alignment slots on both sides of the inner transmission housing.
17.
Make sure the oil seal is not damaged and confirm that the seal is positioned slightly lower than flush with the surface of the housing.
