Forenza L4-2.0L (2004)
6. Remove the seal from the joint assembly.
Installation
1. Install a new small seal retaining clamp onto the seal. Do not crimp.
2. Install the seal onto the axle shaft.
3. Install the joint assembly onto the axle shaft.
4. Install the shaft retaining ring using the snap ring pliers J-8059.
5. Fill the joint assembly with 120 to 140 g (4.2 to 4.9 ounces) of the recommended grease. Repack the tripot with 120 to 140 g (4.2 to 4.9 ounces)
of the recommended grease.
6. Install the a new large seal retaining clamp.
7. Crimp the new large seal retaining clamp using the seal clamp pliers J-35566.