Grand Vitara 2WD V6-2.5L (2004)
2) In order to remove sensor rotor (retainer ring) (2) from shaft (1) , grind with a grinder two portion (4) of the sensor rotor (retainer ring) as shown
till it becomes thin.
CAUTION:
^
Cover vinyl sheet (3) or the like over wheel bearing so that fine grains from grinding will not enter there.
^
Be careful not to go so far as to grind the retainer ring.
3) Break with a chisel (1) the thin ground sensor rotor (retainer ring), and it can be removed.
Installation
1) Press-fit new sensor rotor (retainer ring) (1) as shown in the figure.
2) Install rear axle shaft assembly referring to Rear Axle Shaft and Wheel Bearing Removal and Installation.
