Grand Vitara 2WD V6-2.5L (2004)
Operator's Manual to update the Database files. This step is only required to be done once to accommodate all vehicles covered under this TSB.
NOTE:
This Database "4_DATABASE1.EXE" has been updated with newer data for reprogramming without changing the file name. You are requested to
download in order to update the database in your PC.
5. Following the procedures outlined in the Suzuki Pass-Thru Reprogramming Tool Operator's Manual, hook up the SDS Interface Tool P/N
09910-06520 to the vehicle and run the ECM reprogramming software. If the message "[4028] ECU already has the latest version" appears, click "OK"
and "Finish" and then continue to step 6.
NOTE 1:
If you believe the code "[4028] ECU already has the latest version" is false, check that the Database has been properly installed. See step 4 and try
reprogramming again. If after installing the Database properly code 4028 appears again, no further action is required.
NOTE 2:
If the error code "[4040] Error occurred while rewriting. The programming is aborted." appears click "OK" and then click "Finish" and use the
following procedure.
A. Turn OFF the ignition.
B. Disconnect the negative battery cable.
C. Disconnect the ABS controller connector at the ABS control unit.
D. Reconnect the negative battery cable.
E. Start the reprogramming procedure again.
F. After reprogramming is complete, disconnect the negative battery cable.
G. Reconnect the ABS connector.
H. Reconnect the negative battery cable.
I. Continue to step 6.
