Grand Vitara 2WD V6-2.5L (2004)
Manifold Pressure/Vacuum Sensor: Testing and Inspection
Manifold Absolute Pressure Sensor Inspection
1. Check sensor O-ring (1) for damage and deterioration. Replace as necessary.
2. Arrange 3 new 1.5 V batteries (2) in series and connect its positive terminal to "Vin" terminal and negative terminal to "Ground" terminal. Then
check voltage between "Vout" and "Ground".
Also, check if voltage reduces when vacuum is slowly applied up to 400 mmHg by using vacuum pump (3). If check result is not satisfactory,
replace manifold absolute pressure sensor (1).
CAUTION: As connection to wrong terminal will cause damage to manifold absolute pressure sensor, make absolutely sure to connect properly
as shown in figure.
Manifold absolute pressure sensor output voltage ("Vin" voltage 4.5 - 5.5 V, ambient temp. 20 - 30 °C (68 - 86 °F))
