Grand Vitara 2WD V6-3.2L (2010)
7. Rotate the water pump pulley so the adhered shop cloth is located in line behind the bolt (1).
8. Loosen the bolt (2) using an open-end wrench.
9. Remove the tensioner body along with the upper bolt (the bolt cannot be removed with the tensioner body still in place).
Installation Procedure
10. Place the NEW tensioner assembly (countermeasure part) in a soft jawed vise (1) and remove tensioner pulley bolt (2).
Note:
Take care not to fasten the tensioner too tightly in the vise. Excessive tightening of the vise jaws will deform the tensioner.
11. Disassemble the NEW tensioner assembly to separate the tensioner body (1), the pulley (2), the pulley shield (3) and the tensioner pulley bolt (4).
