Grand Vitara 2WD V6-3.2L (2010)
Housing Assembly HVAC: Service and Repair
HVAC Unit Removal and Installation
HVAC Unit Removal and Installation
Removal
WARNING:
Failure to follow the following procedure and WARNING may cause air bag deployment, personal injury, damage to parts, or air bag being
unable to deploy.
-
Never rest a steering column assembly on steering wheel with air bag (inflator) module face down and column vertical.
-
When handling the air bag (inflator) modules (driver and passenger), be careful not to drop it or apply an impact to it. If an excessive
impact was applied (e.g., dropped from a height of 91.4 cm (3 feet) or more, never attempt disassembly or repair but replace it with a new
one.
-
When grease, cleaning agent. Oil, water, etc. has got onto air bag (inflator) modules (driver and passenger), wipe off immediately with a
dry cloth.
1. Disconnect negative (-) cable at battery.
2. Disable air bag system referring to Disabling Air Bag System:Advanced Air Bag or Disabling Air Bag System:Except Advanced Air Bag.
3. Recover refrigerant from A/C system using recovery and recycling equipment referring to Recovery in Operation Procedure for Charging A/C
with Refrigerant.
4. Drain engine coolant and disconnect heater hoses (1) from HVAC unit.
5. Disconnect suction hose (2) and condenser outlet hose (3) by removing attaching bolt (4).
6. Remove instrument panel.
7. Disconnect rear duct from HVAC unit.
8. Detach wiring, connectors and clamps from HVAC unit.
9. Remove HVAC unit (1).
