Grand Vitara 2WD V6-3.2L (2010)
Receiver Dryer: Service and Repair
Desiccant Removal and Installation
Removal
1. Remove condenser assembly from vehicle.
2. Remove circlip (4) using special tool.
Special Tool: 09900-06107
3. Remove the filter (1) from the receiver / dryer tank (2).
4. Remove desiccant (3).
Installation
Reverse removal sequence to install desiccant, according to instruction manual with supply parts.
NOTE:
-
Replenish specified amount of compressor oil to compressor suction side referring to Precautions on Replenishing Compressor Oil.
-
Install circlip (1) as shown in figure.
