Grand Vitara 2WD V6-3.2L (2010)
17. Install tensioner pulley (1), pulley shield (2) and tensioner pulley bolt (3).
Note:
Off-centering of the pulley shield hinders tightening of pulley bolt. Tighten pulley bolt while centering pulley shield.
18. Tighten the tensioner pulley bolt (3) to the specified torque.
Note:
When tightening the tensioner pulley bolt, turn the tensioner up to the swing end, and then apply specified torque.
19. Remove the portion of shop towel from the water pump pulley.
Note:
Check the water pump pulley for any abrasion caused by replacement of the tensioner and touch up as necessary.
20. While keeping the tensioner (1) in the clockwise turned position with wrench (3), install generator drive belt (2) and then gently release the
tensioner.
Note:
Do not turn the tensioner with a torque greater than 43.5 lbf-ft (59 N.m, 6.0 kgf-m). Over turning may cause damage to the tensioner.
21. Make sure alternator drive belt is installed properly in the grooves of each pulley.
22. Start the engine and check that there is no abnormal noise, and the belt remains positioned in pulley grooves without any failure.
