Grand Vitara 2WD V6-3.2L (2010)
Transmission Temperature Sensor/Switch: Service and Repair
5-Speed Automatic Transmission
Transmission Fluid Temperature Sensor Removal and Installation
Removal
1) Perform Step 1) to 7) of Solenoid Valves (Shift Solenoid-A, Shift Solenoid-B Shift Solenoid-E TCC Pressure Control Solenoid, Pressure Control
Solenoid-A, Pressure Control Solenoid-B and Pressure Control Solenoid-C) Removal and Installation: 5 A/T
2) Remove transmission fluid temperature sensor (8).
3) Disconnect shift solenoid-A connector (1), shift solenoid-B connector (2), shift solenoid-E connector (3), TCC pressure control solenoid connector
(4), pressure control solenoid-A connector (5), pressure control solenoid-B connector (6) and pressure control solenoid-C connector (7).
4) Remove solenoid valves.
5) After removing bolt (1) pull out solenoid connector (2) from transmission case.
CAUTION:
When pulling solenoid wire harness out of transmission case, take care not to damage connectors and transmission fluid temperature
sensor at narrow exist of case. Careless sensor treatment might cause sensor malfunction.
