Grand Vitara 4WD L4-2.4L (2009)
7) Install upper arm.
8) Install rear suspension knuckle.
9) Install rear drive shaft.
10) Install lower arm.
11) Install trailing rod.
12) Install control rod.
13) Install rear wheel hub assembly.
14) Connect rear propeller shaft to differential.
15) Install exhaust muffler and exhaust center pipe.
16) Fill reservoir with brake fluid and bleed brake system.
17) Adjust parking brake cable.
18) Install rear wheels.
19) Check to ensure that brake drum is free from dragging and proper braking is obtained.
20) Bounce vehicle up and down to stabilize suspension.
21) Tighten each bolts and nuts to specified torque with vehicle weight on suspension.
NOTE:
It is the most desirable to have vehicle off hoist and in non-loaded condition when tightening them.
22) Perform brake test (foot brake and parking brake).
23) Check each installed part for fluid leakage.
24) Check rear toe and camber and adjust it if necessary. For check and adjustment procedures.
