Grand Vitara 4WD L4-2.4L (2009)
Knock Sensor: Service and Repair
Knock Sensor Removal and Installation
Removal
1. Disconnect negative cable from battery.
2. Remove intake manifold.
3. Disconnect knock sensor connector.
4. Remove knock sensor (1) from cylinder block.
Installation
Reverse removal procedure noting the following.
-
Install knock sensor (1) as shown in figure.
-
Tighten knock sensor bolt (2) to specified torque.
Tightening torque
Knock sensor bolt (a): 25 N.m (2.5 Kg-m, 18.5 lbf-ft)
