Grand Vitara 4WD L4-2.4L (2009)
10. Make sure the ignition switch is turned off. If the ignition is turned on, or left on, while the reprogramming procedure is performed, DTC(s)
indicating circuit problems may be stored in the SDM.
11. Find the OCS connector, located under the Passenger Seat Cushion, and disconnect it.
Note: You should not need to remove the strap securing the harness.
12. Connect OCS male connector of the vehicle and OCS female connector of K-Line interface cable.
Reprogramming
Note:
Close any software programs running on the PC before reprogramming begins.
13. Make sure the ignition switch is turned off.
14. Check connection between Power supply 100-240V AC, RS232C interface cable, K-Line interface cable, OCS connector and PC.
