Grand Vitara 4WD L4-2.4L (2009)
NOTE: When 60 seconds elapse after engine is started, the above process to enter registration mode will be cancelled. Therefore, be sure to
proceed to the next step within 60 seconds.
5. Turn ignition switch to OFF position.
When ignition switch is turned to OFF position, buzzer sounds twice and door lock is activated from lock position to unlock position. This
operation indicates that keyless start control module has entered registration mode.
6. Push lock or unlock button of remote controller within 30 seconds after Step 5) to be registered.
When lock or unlock button of remote controller is pushed, buzzer sounds twice, door lock is activated to lock position and then to unlock
position. This operation indicates that remote controller ID code has been registered in keyless start control module. If an additional remote
controller needs to be registered, repeat the procedure of Step 6) within 30 seconds after Step 5).
7. To end registration mode, remove ignition key from ignition key cylinder or turn it to ON position.
In case of vehicle equipped with immobilizer control system, if engine start function of keyless start system does not work after registration, check
ECM if DTC P1615 is detected. If it is detected, go to DTC P1615: Steering Lock Unit Communication Error (for Vehicle with Keyless Start
System). See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/P Code Charts/P1615 If it is not detected, perform registration procedure again.
