Grand Vitara 4WD V6-2.5L (2003)
Not Using SUZUKI Scan Tool
1) Check that basic brake system other than ABS is in good condition.
2) Check that battery voltage is 11 Volts or higher.
3) With "ABS" warning lamp, check that no abnormality is detected in ABS. Refer to DTC Check: Type 1.
4) Lift up vehicle.
5) Set transmission to neutral and release parking brake.
6) Turn each wheel gradually by hand to check if brake dragging occurs. If it does, correct.
7) With diag. switch terminal (2) of diagnosis connector (1) connected to ground terminal (3) by using service wire (4), turn ignition switch to ON
position and check that ABS warning lamp indicates normal DTC (DTC 12) referring to DTC Table: Type 1.
8) Turn ignition switch to OFF position.
