suzuki Workshop Repair Guides

Suzuki Workshop Service and Repair Manuals

Electronic Brake Control Module|Type 1|Page 2593 > < Electronic Brake Control Module|Type 1|Page 2591
Page 4
background image

9) Check that brake force is depressurized (about 0.5 seconds) and wheel turns as follows. 

a) Depress brake pedal (1).
b) Turn ignition switch to ON position by one person.
c) Turn wheel by another person's hand.

At this time, check that:
^

Operation sound of solenoid is heard and wheel turns only about 0.5 seconds (brake force is depressurized).

^

Operation sound of pump motor is heard and pulsation is felt at brake pedal.

10) If all 4-wheels cannot be checked during one ignition cycle (OFF , ON), repeat Steps 8) and 9) till all 4 wheels are checked.

If a faulty condition is found in Steps 9) and 10), replace hydraulic unit/control module assembly.

11) Turn ignition switch to OFF position and remove service wire from diagnosis connector.

Electronic Brake Control Module|Type 1|Page 2593 > < Electronic Brake Control Module|Type 1|Page 2591