Grand Vitara 4WD V6-2.5L (2003)
Brake Master Cylinder: Service and Repair
Master Cylinder Reservoir Replacement
Removal
1. Disconnect reservoir lead wire at coupler.
2. Clean outside of reservoir (1).
3. Take out fluid with syringe or such.
4. Remove reservoir connector pin by using special tool or remove connector screw.
Special tool
(A): 09922-85811
5. Remove reservoir (1).
NOTE: Do not allow brake fluid to get on painted surfaces.
Installation
NOTE: See NOTE at the beginning of the section.
1. When using new grommets, lubricate them with the same fluid as the one to fill reservoir with. Then press-fit grommets to master cylinder.
Grommets must be seated in place.
