Grand Vitara 4WD V6-2.5L (2003)
Fuel Tank Pressure Sensor: Testing and Inspection
Fuel Tank Pressure Sensor Check
1. Remove fuel tank pressure sensor (1) from fuel tank.
2. Check sensor air vent hole (5) and pressure passage for clog. Clean if clogged.
3. Arrange 3 new 1.5 V batteries (2) in series (check that total voltage is 4.5 - 5.0 V) and connect its positive terminal to "Vin" terminal of sensor and
negative terminal to "Ground" terminal.
Then check voltage between "Vout" and "Ground". Also, check if voltage reduces when vacuum is applied up to 6.6 kPa (50 mmHg) by using
vacuum pump (3) and if it increases when positive pressure is applied up to 6.6 kPa (50 mmHg) by using hand pump.
If measured voltage doesn't show such characteristic as shown in figure, replace.
CAUTION:
-
As connection to wrong terminal will cause damage to tank pressure sensor, make absolutely sure to connect properly as shown.
-
Do not apply pressure higher than 98 kPa (742 mmHg) to tank pressure sensor by hand pump. Applying excessive pressure will break it.