Grand Vitara 4WD V6-2.5L (2003)
NOTE: When it is impossible to install wheel hub component by hand, which means the inner race is out of alignment, remove wheel hub
component once and reinstall it.
4. Install bearing washer, and then install wheel bearing lock nut.
5. Tighten wheel bearing lock nut to specified torque while turning wheel hub by hand.
Special tool
(A): 09951-16050
Tightening torque
Wheel bearing lock nut (a): 216 Nm (21.6 kg-m, 156.5 ft. lbs.)
6. Using lock washer (1), lock bearing lock nut. If lock screw hole is not aligned with screw hole in lock nut, turn lock nut in tightening direction till
they align.
Tightening torque
Lock bearing lock screw (a): 1.5 Nm (0.15 kg-m, 1.1 ft. lbs.)
7. For 4WD vehicle, apply lithium grease "A" to front drive shaft washer and front wheel spindle outer.
"A": Grease 99000-25010
