Grand Vitara 4WD V6-2.5L (2003)
14. Remove stud bolt(s) (1) by using hydraulic press (2).
Installation
Install removed parts in reverse order of removal procedure, noting the followings.
1. Apply grease "A" to oil seal lip (2) of bearing retainer (1) as shown in the figure and install it to axle shaft.
NOTE: A mount of grease applied to hollow in oil seal should be more than 60% of its vacant space.
"A": Grease 99000-25010
2. Aligning serrations between new stud bolt(s) (1) and flange (4), install new stud bolt(s) (1) by tightening nut (2) as shown in the figure.
3. Install bearing retainer (2) to axle shaft (1).
