Grand Vitara 4WD V6-2.5L (2003)
Four Wheel Drive Selector Switch: Service and Repair
Transfer 4WD Switch Removal and Installation
1) Remove console box and lift transmission control lever boots No. 2 and No. 3.
2) Remove transfer control lever boot No. 2 (3), unclamp wiring on transfer case to free it and pull off coupler (1).
3) Replace 4WD switch (2) and connect as it was.
4) Turn ON ignition switch, shift transfer shift control lever to 4WD position and check that indicator lights. Turn OFF switch after checking.
NOTE:
^
When removing and reinstalling switch, use care not to lot dust enter transfer box inside.
^
Make sure to reset clamp for wiring which is located where invisible directly.
^
It is recommended to work on transfer shift control lever boot No.1 from underside of vehicle on lift.
^
Identify 4WD switch (2) by its log part which is different for that of back up light switch (1).
