Grand Vitara 4WD V6-3.2L (2010)
3) Connect harness clamp to bracket.
4) Install ECM referring to Engine Control Module (ECM) Removal and Installation:N32A or ECM (Engine Control Module) Removal and
Installation:J24B.
5) Connect negative (-) cable at battery.
6) Bleed air from brake system.
7) Check each installed part for fluid leakage.
8) For ESP model, perform Sensor Calibration of ESP Components.
9) Perform ABS Hydraulic Unit Operation Check or ESP Hydraulic Unit Operation Check.
10) Turn ignition switch to OFF position once and then ON position. In this state, make sure that warning / indicator lights are turn off.
11) Check DTC(s) are not stored in hydraulic unit / control module.
